How-to Install ESX 4 inside VMware Workstation 7 video

11 Comments

1. Roy Mikes

   Posted on November 8, 2009 at 9:21 am

   It's the same as in Workstation 6.5. But good video!

   http://www.mikes.eu/index.php?option=com_conten...

   Reply
2. Vladan

   Posted on November 8, 2009 at 10:51 am

   Not the same because VMware ESX as an OS, all the config necessary is automatically selected. (like 2gig RAM etc..)…..-:)

   Reply
3. Roy Mikes

   Posted on November 18, 2009 at 4:25 am

   Ok Besides that it's about the same.

   Reply
4. Ragesh

   Posted on February 11, 2010 at 9:18 am

   Hi ,

   Have a question, If esx 4 installed in Ws7 (with 2 virtual NIC’s in Ws7) after installation will these virtual Nic’s come up as 2 physical adapters(not physical in real sense) when administering the esx via vsphere client. I tried this 2 nics shows up during esx install but after install I cannot do a ping to the esx host.Can you point out where I am going wrong.

   Thanks
   ragesh

   Reply
   • Vladan SEGET

     Posted on February 11, 2010 at 12:01 pm

     Make sure that those 2 nics are used as a “bridged” option in Settings for this ESX 4 VM…. -:) That’s more likely the cause..

     Reply
5. BalaKumar

   Posted on February 15, 2010 at 3:24 am

   Thanks a lot for your Help

   Reply
6. Adam

   Posted on April 13, 2010 at 9:24 am

   there is a small typo in the header.. you wrote: Workstaiton i think you mean workstation

   Reply
   • Vladan SEGET

     Posted on April 14, 2010 at 12:27 pm

     Thanks,

     It’s impossible to not doing a typos with this amount of information… -:)

     Reply
7. volkan

   Posted on August 20, 2010 at 7:50 pm

   Thanks.

   Reply

Trackbacks and Pingbacks

1. مشکل در نصب esx 3.5 روی vmware ws 7.0
2. Running two VMware ESXi 4.1 on only 2GB RAM - Kasraeian